Send Message
Home News

company news about The development effect of such a pressure transmitter is really good

Certification
China Changsha Taihe Electronic Equipment Co. certification
China Changsha Taihe Electronic Equipment Co. certification
Customer Reviews
I ordered the product and used it, it was good and I would recommend dealing with the company.

—— F**************r

Fully satisfied, fast charging, courteous and good handling. Worth buying from them, and also very good prices. And also the seller is keen on product safety and prompt response .

—— D**********E

What was ordered is what was delivered. Highly recommend them on matters of digital pressure sensors

—— J**********a

I'm Online Chat Now
Company News
The development effect of such a pressure transmitter is really good
Latest company news about The development effect of such a pressure transmitter is really good

The development effect of such a pressure transmitter is really good. It can be seen that various high-performance self 700 pressure sensor have been designed based on different measurement principles recently, and personalized customization can be made according to customer requirements.

 

The temperature range of the pressure transmitter is divided into the compensation temperature range of+c (or directly referred to as the compensation temperature range). The compensation temperature range is suitable for the temperature range of the process, as shown in Table 1-2kpa. In order to overcome the additional errors caused and avoid them. Temperature range compensation is suitable for additional applications such as fastening screw pressure ports, nut pressure ports, rubber rings, tire inflation diaphragm type rubber, and so on.

However, such a multi-purpose mechanical pressure transmitter, also known as a flat film pressure sensor, is used to measure the water level of very viscous and impure liquids.

 

The advantage of a pressure transmitter is its high accuracy, which can linearly convert the measured liquid level value into a 4-20mADC signal and transmit it to the secondary instrument, without any special requirements for the secondary instrument.

When installing, plug and unplug the transmitter from any component at the bottom of the pool, and replace them with the original wiring method.

 

This product is suitable for oil pressure damage detection of railways with a total pressure of 28000kg/m at the rear of railway diesel locomotives.

The product is installed on the top of the metal structure. To prevent organic chemical solvents from entering the electrical equipment, it is recommended to install the electrical equipment and avoid riots.

 

The detection transmitter and the high-pressure zone bend sensor are installed separately, and the two probes can be installed at a shorter distance in the high-pressure zone.

Due to the special environmental characteristics of the product, it is recommended to ground the equipment with a room. Poor grounding can cause unstable output of the controllable rectifier bridge, so a ground wire connector is required.

 

This product is mainly used for safety inspection of railways with a total pressure of 5800kg/m at the rear of railway diesel locomotives. When an overspeed occurs, physical methods can be used to determine whether it has occurred and whether the pipe has malfunctioned.

Operators must have a dose of 45000 times, a speed limit of 2 times or more, and a speed limit of 42000 hours.

latest company news about The development effect of such a pressure transmitter is really good  0

Determine 4. Check the distance between floor drain C, U, and L, L, and L, as well as the depth of L or L. You can then choose to proceed with the next step.

Use ETH as a scale, with the number displaying "L" and "Q", and adjust the scale, taking care to ensure that L applies force to the sensor through the rod shaped number of V.

This is also a direct operation of the sensor itself with a printing board card.

Pub Time : 2023-10-30 12:03:47 >> News list
Contact Details
Changsha Taihe Electronic Equipment Co.

Contact Person: Mr. William

Send your inquiry directly to us (0 / 3000)