Send Message
Changsha Taihe Electronic Equipment Co.
Changsha Taihe Electronic Equipment Co.
news
Home / news /

Company News About You definitely like this oil moisture sensor

You definitely like this oil moisture sensor

2023-10-24
You definitely like this oil moisture sensor

You definitely like this type of oil moisture sensor. We all know that car oil moisture sensor do not require human detection, so it doesn't matter which type of gasoline engine sensor can detect engine idling and automatically remind the engine staff to perform air change and ignition functions. However, if it is necessary to pay attention to the condition of engine idling and stalling, it is usually recommended to use an oil moisture sensor to monitor the engine idling and stalling. This is mainly done by preparing an oil moisture sensor. The detection of the oil moisture sensor usually requires the following two steps.

 

When measuring, it is necessary to consider the viscosity of the coolant. This is mainly due to the deposition of oil. The higher the temperature or viscosity during the deposition, the higher the subsequent water content of the oil. There is no need to increase the oil. The closer the temperature of the oil is to a certain point, the more likely it is to have an impact on the measurement. The final measured value will be different or have a sufficiently high viscosity value. To check for any problems, it is necessary to check the viscosity value of the lubricating oil, The main thing is to see if the water content of the engine oil is average, hoping that the same phenomenon will not occur in ten years, in order to avoid it.

 

Capable of measuring viscosity and viscosity values. In principle, the direct measurement is the viscosity value of lubricating oil without any errors. Currently, the accuracy of lubricating oil viscosity measurement is generally around 10-15, and the measurement accuracy can be controlled around 10-15. The measurement range is larger, and when starting a business, special attention should be paid to the density of lubricating oil. Although it can be measured on a daily basis, if there are any problems, it is necessary to try other experiments.

 

It can measure the viscosity value of oil with high accuracy, usually up to 0-2%. This value is generally controlled around 0-5, and the number of revolutions is generally not more than one hundred thousandth. However, a single value or a control value can reach 10-20 times, and some even have revolutions generally controlled between -10 and 0-5, and the number of revolutions generally does not exceed one thousandth. By dividing the number of revolutions into four or two, we can determine the viscosity value of the oil based on this value, If the viscosity value does not exceed 100, it can be reconciled, and the viscosity value of the measured viscosity value is generally equal to 1500.

Rotor viscosity: screw, fine screw, rotor with changes in equipotential, edge winding, and self weight, with very small rotational clearance and generally cannot exceed the range

latest company news about You definitely like this oil moisture sensor  0

The smaller my resistance value, the slower the change in speed, and the slower the change in delta value.

Generally, if the number of pulses in a certain direction is the same, the more pulses in a tachometer, the error in the measurement value will occur. If the directions are different, there is an error in the measurement value, which is caused by the error of the tachometer. The first thing we need to think about is the error of the measurement quantity. For the error of the measurement quantity, we can think that the smaller the error, the better. For its error, we can think that the smaller the better.

 

Therefore, for errors that are much larger, it can be considered that smaller is better for error calculation. For error calculation, it is generally believed that a smaller error range is better. The reason for this is not only the geometric information of the instrument or sensor, but also the circuit, which means that a smaller circuit parameter is better.